Hi Joe,
On 10/06/11 23:50, Joe Hershberger wrote:
> Enable the gpio command
>
> Signed-off-by: Joe Hershberger <joe.hershber...@ni.com>
> Cc: Joe Hershberger <joe.hershber...@gmail.com>
> Cc: Sandeep Paulraj <s-paul...@ti.com>
> ---
> Changes for v2:
> - Correct a bad merge... sorry.
>
> board/ti/panda/panda_mux_data.h | 2 +-
> include/configs/omap4_panda.h | 3 +++
> 2 files changed, 4 insertions(+), 1 deletions(-)
>
> diff --git a/board/ti/panda/panda_mux_data.h b/board/ti/panda/panda_mux_data.h
> index 63448b6..c692c7b 100644
> --- a/board/ti/panda/panda_mux_data.h
> +++ b/board/ti/panda/panda_mux_data.h
> @@ -212,7 +212,7 @@ const struct pad_conf_entry
> wkup_padconf_array_non_essential[] = {
> {PAD0_FREF_SLICER_IN, (M0)}, /* fref_slicer_in */
> {PAD1_FREF_CLK_IOREQ, (M0)}, /* fref_clk_ioreq */
> {PAD0_FREF_CLK0_OUT, (M2)}, /* sys_drm_msecure */
> - {PAD1_FREF_CLK3_REQ, M7}, /* safe
> mode */
> + {PAD1_FREF_CLK3_REQ, M7}, /* safe mode */
> {PAD0_FREF_CLK3_OUT, (M0)}, /* fref_clk3_out */
> {PAD1_FREF_CLK4_REQ, (PTU | M3)}, /* led status_1 */
> {PAD0_FREF_CLK4_OUT, (PTU | M3)}, /* led status_2 */
> diff --git a/include/configs/omap4_panda.h b/include/configs/omap4_panda.h
> index 67da70e..b88e5ad 100644
> --- a/include/configs/omap4_panda.h
> +++ b/include/configs/omap4_panda.h
> @@ -35,6 +35,9 @@
>
> #include <configs/omap4_common.h>
>
> +/* GPIO */
> +#define CONFIG_CMD_GPIO 1
Boolean defines should not have a value.
--
Regards,
Igor.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
