A delay of approximately 250 ms after PCI bus reset in pci_mpc5xxx_init() is needed to recognize the Coral-PA controller on the graphic extention board.
Signed-off-by: Anatolij Gustschin <ag...@denx.de> --- To make it actually work another patch "pci: move pcidelay code to new location just before PCI bus scan" is also required. It has been submitted earlier [1] and there is already some positive feedback. [1] http://patchwork.ozlabs.org/patch/119171/ include/configs/digsy_mtc.h | 1 + 1 files changed, 1 insertions(+), 0 deletions(-) diff --git a/include/configs/digsy_mtc.h b/include/configs/digsy_mtc.h index 522ec57..d0d1eda 100644 --- a/include/configs/digsy_mtc.h +++ b/include/configs/digsy_mtc.h @@ -70,6 +70,7 @@ #define CONFIG_PCI 1 #define CONFIG_PCI_PNP 1 #define CONFIG_PCI_SCAN_SHOW 1 +#define CONFIG_PCI_BOOTDELAY 250 #define CONFIG_PCI_MEM_BUS 0x40000000 #define CONFIG_PCI_MEM_PHYS CONFIG_PCI_MEM_BUS -- 1.7.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot