For some reason code setting the speed based on the PHY feedback causes
troubles on AM3517 so hardcode 100Mbps for now.
Signed-off-by: Ilya Yanok <ya...@emcraft.com>
---
drivers/net/davinci_emac.c | 3 ++-
1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c
index 4318a39..a35ebeb 100644
--- a/drivers/net/davinci_emac.c
+++ b/drivers/net/davinci_emac.c
@@ -461,7 +461,8 @@ static int davinci_eth_open(struct eth_device *dev, bd_t
*bis)
writel(1, &adap_emac->RXUNICASTSET);
/* Enable MII interface and Full duplex mode */
-#ifdef CONFIG_SOC_DA8XX
+#if defined(CONFIG_SOC_DA8XX) || \
+ (defined(CONFIG_OMAP34XX) && defined(CONFIG_DRIVER_TI_EMAC_USE_RMII))
writel((EMAC_MACCONTROL_MIIEN_ENABLE |
EMAC_MACCONTROL_FULLDUPLEX_ENABLE |
EMAC_MACCONTROL_RMIISPEED_100),
--
1.7.6.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
