On 10/31/2011 06:01 PM, Helmut Raiger wrote: > Hi (Stefano), > > just a short question. I'd like to add NAND boot to the board > support of our TT-01. > I checked out the mx31pdk code and also found something in doc/README.SPL > which does not seem to correspond.
Right. A lot of work was done recently, and now there is a common SPL framework in u-boot. The README.spl refers to the new stuff. Before of that, booting from NAND was done in a different manner. This is what you find under board/freescale/mx31pdk. The mx31pdk is booting with the old mechanism. New boards must implement the SPL according to the new framework, using CONFIG_SPL and setting the SPL configuration in the board configuration file. I am expecting Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot