2011/10/31 Igor Grinberg <grinb...@compulab.co.il>
> > +struct mxc_ulpi_regs {
> > + u8 vendor_id_low; /* 0x00 - Vendor ID lower byte */
> > + u8 vendor_id_high; /* 0x01 - Vendor ID upper byte */
> > + u8 product_id_low; /* 0x02 - Product ID lower byte */
> > + u8 product_id_high; /* 0x03 - Product ID higher byte */
> > + /* Function Control; 0x04 - 0x06 Read, 0x04 Write */
> > + u8 function_ctrl_write;
> > + u8 function_ctrl_set; /* 0x05 Set */
> > + u8 function_ctrl_clear; /* 0x06 Clear */
> > + /* Interface Control; 0x07 - 0x09 Read, 0x07 Write */
> > + u8 iface_ctrl_write;
> > + u8 iface_ctrl_set; /* 0x08 Set */
> > + u8 iface_ctrl_clear; /* 0x09 Clear */
> > + /* OTG Control; 0x0A - 0x0C Read, 0x0A Write */
> > + u8 otg_ctrl_write;
> > + u8 otg_ctrl_set; /* 0x0B Set */
> > + u8 otg_ctrl_clear; /* 0x0C Clear */
> > + /* USB Interrupt Enable Rising; 0x0D - 0x0F Read, 0x0D Write */
> > + u8 usb_ie_rising_write;
> > + u8 usb_ie_rising_set; /* 0x0E Set */
> > + u8 usb_ie_rising_clear; /* 0x0F Clear */
> > + /* USB Interrupt Enable Falling; 0x10 - 0x12 Read, 0x10 Write */
> > + u8 usb_ie_falling_write;
> > + u8 usb_ie_falling_set; /* 0x11 Set */
> > + u8 usb_ie_falling_clear; /* 0x12 Clear */
> > + u8 usb_int_status; /* 0x13 - USB Interrupt Status */
> > + u8 usb_int_latch; /* 0x14 - USB Interrupt Latch */
> > + u8 debug; /* 0x15 - Debug */
> > + /* Scratch Register; 0x16 - 0x18 Read, 0x16 Write */
> > + u8 scratch_write;
> > + u8 scratch_set; /* 0x17 Set */
> > + u8 scratch_clear; /* 0x18 Clear*/
> > +};
>
>
> These are the generic ULPI specification registers
> and not mxc specific.
> I'd expect to have them in a more generic location.
>
This would be fixed in general ULPI support patch I'm working on. It should
be ready for posting in a few days.
> --
>
Regards,
> Igor.
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
