> -----Original Message----- > From: Simon Guinot [mailto:si...@sequanux.org] > Sent: Monday, October 31, 2011 7:29 PM > To: Prafulla Wadaskar > Cc: u-boot@lists.denx.de; Simon Guinot > Subject: [PATCH 2/3] netspace_v2: enable I2C EEPROM support > > From: Simon Guinot <simon.gui...@sequanux.org> > > An I2C EEPROM HT24LC04 (512B) is available on the netspace_v2 > board > (and parents). This EEPROM hold data such as Ethernet MAC > addresses > and power flags. > > Signed-off-by: Simon Guinot <simon.gui...@sequanux.org> > --- > include/configs/netspace_v2.h | 11 +++++++++++ > 1 files changed, 11 insertions(+), 0 deletions(-) > > diff --git a/include/configs/netspace_v2.h > b/include/configs/netspace_v2.h > index 5790602..bb27ed7 100644 > --- a/include/configs/netspace_v2.h > +++ b/include/configs/netspace_v2.h > @@ -108,6 +108,17 @@ > #define CONFIG_KIRKWOOD_GPIO > > /* > + * Enable I2C support > + */ > +#ifdef CONFIG_CMD_I2C > +/* I2C EEPROM HT24LC04 (512B - 32 pages of 16 Bytes) */ > +#define CONFIG_CMD_EEPROM > +#define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 > +#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 4 /* 16-byte page > size */ > +#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1 /* 8-bit device > address */ > +#endif /* CONFIG_CMD_I2C */ > + > +/* > * File systems support > */ > #define CONFIG_CMD_EXT2 > --
Applied to u-boot-marvell.git master branch Regards.. Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot