On Mon, Dec 5, 2011 at 2:19 AM, rojan <rojan....@bpltelecom.com> wrote: > I have OMAP L138 Hawkboard which is loaded with some other program. > I am new to this hawkboard and tried to boot as per instructions from > user guide in http://www.hawkboard.org/ , system is not coming to > hawkboard.org > to access command. It is coming as follows. > > Please help me to make it ready. > > Switch positions made as follows > > Pin1 = ON > Pin2 = OFF > Pin3 = OFF > Pin4 = OFF > > Terminal data as follows: > > U-Boot 2009.01-dirty (Nov 26 2009 - 02:15:00) > > DRAM: 128 MB > NAND: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xa1 (Micron NAND > 128MiB 1,8 > V 8-bit) > Bad block table found at page 65472, version 0x01 > Bad block table found at page 65408, version 0x01 > nand_read_bbt: Bad block at 0x03500000 > nand_read_bbt: Bad block at 0x049a0000 > 128 MiB > In: serial > Out: serial > Err: serial > ARM Clock : 300000000 Hz > DDR Clock : 150000000 Hz > Ethernet PHY: GENERIC @ 0x07 > Hit any key to stop autoboot: 0
During this countdown you need to 'hit any key' to stop the boot from happening and give you the U-Boot prompt. -- Tom _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot