On 06/12/2011 19:34, Simon Schwarz wrote: > Adds direct Linux boot to SPL. It implements a spl export command to save > ATAGS or FDT to NAND flash. The kernel image has to be in place for this! > > Changes in V5: > - Rebased on u-boot-ti > - fixed MAKEALL warnings and errors > - adapted to general gpio interface > Changes in V6: > - Change old commit message > > Changes in V7: > - Correct style and format errors > > Changes in V8: > - rebased on u-boot > > Changes in V9: > - Deleted a left-over patch from the series this also fixed the first > problem mentioned here: > - http://article.gmane.org/gmane.comp.boot-loaders.u-boot/119452 > > based on: > - Prep subcommand patch for arm > (http://article.gmane.org/gmane.comp.boot-loaders.u-boot/106725)
Hi Simon, I am testing your patches (V9) - the kernel image is not corrupted anynmore due to the ECC, but I am not able to boot successfully the kernel. I am testing now with a second hardware (twister, I have recently posted the patches for this board, also OMAP3) to have a comparison with the beagleboard. The kernel starts but it stops very soon, I think after the machine-id check and it seems it cannot poarse correctly the tags. However, the parameters exported by "spl export" are correct and I have not found any difference with the "bootm" command under U-boot. I am starting to debug the kernel to get some more infos, but do you have some hints ? How do you test it ? Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot