Dear vikas.sonta...@emc.com, In message <629d989c137dd040a0a994bd21888f1e75e81...@mx29a.corp.emc.com> you wrote: > > I have built a new u-boot for a board which is very similar to canyonlands. > But I am having problem in running it. Afterwards, I ran mkimage on it.
Why did you do that? > I then tftp the image "u-boot.bin.load" and bootm it but I am getting > following error. > Error: Bad gzipped data > GUNZIP: uncompress or overwrite error - must RESET board to recover What makes you think this could work? There is no documentation anywhere that desribes such an approach, so why do you think this could work? Why don't you simply read the DULG for the canyonlands board an follow the steps described there to install a new U-Bootimage? > Board: Mellanox PPC460EX Board Be careful. Even if boards are similar the code for one board (canyonlands) will most certainly NOT run on different hardware (even if you consider the differences to be small). Make sure you have a JTAG debugger at hand in case you brick your board (alternatively, make sure you have a working boot image in NAND for recovery). Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Experience is what causes a person to make new mistakes instead of old ones. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot