On Mon, Dec 19, 2011 at 23:26, Michael Kebe <michael.k...@gmail.com> wrote: > Thanks, for the hint! There is TEXT_BASE = 0x60d00000. > > Here is the output from a bootup of the old U-Boot: > -------------------- > Stage-1 Bootloader Tue Aug 9 16:44:00 CST 2011 > Attempting to set PLLA to 750MHz ... > plla_ctrl0 : 0x0000000A > plla_ctrl1 : 0x000F0000 > plla_ctrl2 : 0x001D01A0 > plla_ctrl3 : 0x00000017 > PLLA Set > > Setup memory, testing > Reading NAND, Image 0 > Hdr len: 0x0001A94C > Hdr CRC: 0xF0019DAC > OK > > > U-Boot 1.1.2 (Jun 24 2011 - 09:41:57) > > U-Boot code: 60D00000 -> 60D1A94C BSS: -> 60D1F004 > RAM Configuration: > Bank #0: 60000000 128 MB > SRAM Configuration: > 64KB at 0x50000000 > NAND:128 MiB > In: serial > Out: serial > Err: serial > Setting Linux mem= boot arg value > Hit any key to stop autoboot: 0 > -------------------- > > Is the "U-Boot code" the address CONFIG_SYS_UBOOT_BASE should be set > to? If so, then both addresses are the same, is that ok?
Thanks for the discussion about how to port a new board into U-Boot. But I think these questions are forgotten, any further hints? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot