Dear Tom Rini, In message <CA+M6bXn_ZBqA8rosE4L4O+4Eu+grAhWgCZ=u=2nomb6wcyl...@mail.gmail.com> you wrote: > > > I guess you really, really must use i2c before relocation? =A0If > > possible, this should be avoided in the first place. > > Yes, board rev detection to know how to configure SDRAM.
I don't consider this a valid reason (reading the SPD EEPROM would be such a reason). In almost all other cases it should be suffucient to configure the maximum number of memory banks and the maximum size of the memory banks and then use get_ram_size() to determine the actual amount of memory and to correctly initialize the memory controller. Note that I don't insist on any changes to existing code here. This is just a recommendation which you may (or may not) consider for any future ports / implementations. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de How much net work could a network work, if a network could net work? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot