Hi,
I noticed a problem while testing Wolfgang's patch
PPC: fix "Warning: FOO uses hard float, BAR uses soft float".
U-Boot built for TQM5200 using ELDK-5.1 powerpc toolchain
seems to have issues in CPU POST test. I see similar problem
both with and also without Wolfgang's patch applied:
U-Boot 2011.12-rc3-00002-gaf44f4b (Dec 23 2011 - 00:08:10)
CPU: MPC5200 v1.2, Core v1.1 at 396 MHz
Bus 132 MHz, IPB 132 MHz, PCI 66 MHz
Board: TQM5200 (TQ-Components GmbH)
on a STK52xx carrier board
I2C: 85 kHz, ready
DRAM: 64 MiB
Flash: 32 MiB
In: serial
Out: serial
Err: serial
Net: FEC
POST i2c PASSED
POST cpu Error at multi test !
FAILED
^^^^^^
IDE: Bus 0: OK
Device 0: Model: 32MB CHH Firm: Rev 1.01 Ser#: 403303C48A30730031
Type: Removable Hard Disk
Capacity: 30.5 MB = 0.0 GB (62592 x 512)
Device 1: not available
SRAM: 512 kB
VGA: SMI501 (Voyager) with 8 MB
PS/2: No device found
Kbd: reset failed, no ACK
Type run flash_nfs to mount root filesystem over NFS
Anatolij
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
