> Hi! > > On Thu 2012-02-23 15:49:02, Marek Vasut wrote: > > > On Thursday 23 February 2012 15:17:19 Pavel Machek wrote: > > > > > > My experience is mostly SPEAr600 only right now. Not sure if there are > > > bigger differences between those SoC's in the BootROM. > > > > I believe the spear600 is totally different from 1300. But, simple: > > > > reset halt ; load ... ; go ... > > > > combo should work I believe. In case you're loading some U-Boot SPL, > > > > it's very > > I have a problem here: "reset halt" does not reset the board; probably > some kind of BDI problem. I tried playing with BDI config, but was not > successful. > > I tried to load u-boot from u-boot using: > > u-boot> tftp 0x00700000 192.168.1.1:/spear1310eval/u-boot.bin > > Using mii0 device > TFTP from server 192.168.1.1; our IP address is 192.168.20.47 > Filename '/spear1310eval/u-boot.bin'. > Load address: 0x700000 > Loading: ############## > done > Bytes transferred = 193032 (2f208 hex) > u-boot> go 0x00700000 > ## Starting application at 0x00700000 ... > > > U-Boot 2010.03-lsp-3.0-rc7 (Sep 15 2011 - 13:52:19) > SPEAr-emlix-CCLite-BSP-0.11 > > ...it started something. According to gdb it looks like "new" u-boot > executes briefly, but fails in C code while processing intialization, > and it seems that "old" u-boot takes over. (Some kind of failure and > board resets itself?).
Well yea, loading uboot from uboot isn't supported. > > Any ideas? > Pavel _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot