Dear Tom Rini,
In message <20120315202316.GA6855@bill-the-cat> you wrote:
>
> So, the (normally?) required to work toolchains are ELDK 5.1 and ELDK
> 4.2. 5.1 is fine but with 4.2 (gcc 4.2.2) we get two warnings for every
> file about interworking/thumb not being supported. Further, the
> resulting binary doesn't boot.
>
> However, is this really a problem? I don't imagine folks using ELDK
> 4.2-era tools on OMAP5, and I have a tough time imaging them using it
> for OMAP4.
I don't consider it a big problem (just a bit sad) if ELDK 4.2 cannot
be used for building these. However, I think it is not acceptable
tobuild known-to-be-broken images. If the tool chain is too old, this
shall result in a clear error message and abort of the build.
Why is thumb mode needed for these boards? Just because of image
size?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
It is necessary to have purpose.
-- Alice #1, "I, Mudd", stardate 4513.3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
