In warm reset conditions on OMAP36xx/AM/DM37xx the rom code
incorrectly sets the DPLL4 clock input divider to /6.5 which
is an invalid value unless the input clock is 13MHz. When a JTAG
emulator is attached, a warm reset is necessary after the emulator
gains control of the process. This results in a loss of serial
output due to the invalid DPLL4 settings.
This patch fixes the issue by resetting the DPLL4 clock input
divider to /1 when the input clock is not 13MHz. AM/DM37x TRM
section 3.5.3.3.3.2.1 specifies that the /6.5 setting is only
used when the input clock is 13MHz.
Signed-off-by: Matt Porter <mpor...@ti.com>
---
arch/arm/cpu/armv7/omap3/clock.c | 16 ++++++++++++++++
1 files changed, 16 insertions(+), 0 deletions(-)
diff --git a/arch/arm/cpu/armv7/omap3/clock.c b/arch/arm/cpu/armv7/omap3/clock.c
index 567817e..09c51f6 100644
--- a/arch/arm/cpu/armv7/omap3/clock.c
+++ b/arch/arm/cpu/armv7/omap3/clock.c
@@ -572,6 +572,22 @@ void prcm_init(void)
}
if (get_cpu_family() == CPU_OMAP36XX) {
+ /*
+ * In warm reset conditions on OMAP36xx/AM/DM37xx
+ * the rom code incorrectly sets the DPLL4 clock
+ * input divider to /6.5. Section 3.5.3.3.3.2.1 of
+ * the AM/DM37x TRM explains that the /6.5 divider
+ * is used only when the input clock is 13MHz.
+ *
+ * If the part is in this cpu family *and* the input
+ * clock *is not* 13 MHz, then reset the DPLL4 clock
+ * input divider to /1 as it should never set to /6.5
+ * in this case.
+ */
+ if (sys_clkin_sel != 1) /* 13 MHz */
+ /* Bit 8: DPLL4_CLKINP_DIV */
+ sr32(&prm_base->clksrc_ctrl, 8, 1, 0);
+
/* Unlock MPU DPLL (slows things down, and needed later) */
sr32(&prcm_base->clken_pll_mpu, 0, 3, PLL_LOW_POWER_BYPASS);
wait_on_value(ST_MPU_CLK, 0, &prcm_base->idlest_pll_mpu,
--
1.7.5.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
