Hi,
I am working with a PCIE board from pericom, on bus 0 on a ppc4xx
target klondike board. After the board intiailization when PCI Autoconfig finds
P2P device it shows device 0 and goes on upto bus no. 16 by incrementing
current_busno each time by 1. Each time it displays the same message:
PCI Autoconfig: Found P2P bridge, device 0
It does not find bridge device and further scan on sub bus fails. It starts
with pci_host_scan on bus 0 and at a point it hits pciauto_config_device, from
here it calls pciauto_setup_device. The bar response in here returns not set. I
am not sure if I am missing something here or my BAR registers are not mappped
correctly. I set up only one region count i.e. 0 and set it to pci_mem. Hope to
hear some ideas on this.
Axl.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
