From: Rajashekhara, Sudhakar <sudhakar....@ti.com>
According to DA850/OMAP-L138 schematics, GP2[6] line has to be driven
high for RMII mode to work. In RMII mode, SPI flash becomes un-usable.
But during testing it was found out that, driving GP2[6] low also
enables RMII and in this configuration SPI flash is also accessible.
Signed-off-by: Rajashekhara, Sudhakar <sudhakar....@ti.com>
Signed-off-by: Lad, Prabhakar <prabhakar....@ti.com>
Signed-off-by: Hadli, Manjunath <manjunath.ha...@ti.com>
---
board/davinci/da8xxevm/da850evm.c | 6 +++---
1 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/board/davinci/da8xxevm/da850evm.c
b/board/davinci/da8xxevm/da850evm.c
index 004d5ad..82d707f 100644
--- a/board/davinci/da8xxevm/da850evm.c
+++ b/board/davinci/da8xxevm/da850evm.c
@@ -438,10 +438,10 @@ int rmii_hw_init(void)
CONFIG_SYS_I2C_EXPANDER_ADDR);
}
- /* Set the output as high */
- temp = REG(GPIO_BANK2_REG_SET_ADDR);
+ /* Set the output as low */
+ temp = REG(GPIO_BANK2_REG_CLR_ADDR);
temp |= (0x01 << 6);
- REG(GPIO_BANK2_REG_SET_ADDR) = temp;
+ REG(GPIO_BANK2_REG_CLR_ADDR) = temp;
/* Set the GPIO direction as output */
temp = REG(GPIO_BANK2_REG_DIR_ADDR);
--
1.7.4.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
