Hi Tom and all,
(2012/06/28 3:23), Tom Rini wrote:
On Mon, Jun 25, 2012 at 09:40:57PM +0900, Tetsuyuki Kobayashi wrote:
Interrupts and exceptions doesn't work in relocated code.
It badly use IRQ_STACK_START_IN in rom area as interrupt stack.
It is because the vecotr table is not moved to ram area.
This patch moves vector table before jumping relocated code.
Signed-off-by: Tetsuyuki Kobayashi<k...@kmckk.co.jp>
---
arch/arm/cpu/armv7/start.S | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S
index 52f7f6e..5098f7b 100644
--- a/arch/arm/cpu/armv7/start.S
+++ b/arch/arm/cpu/armv7/start.S
@@ -277,6 +277,18 @@ jump_2_ram:
mcr p15, 0, r0, c7, c10, 4 @ DSB
mcr p15, 0, r0, c7, c5, 4 @ ISB
#endif
+/*
+ * Move vector table
+ */
+#if !defined(CONFIG_TEGRA2)
+#if !(defined(CONFIG_OMAP44XX)&& defined(CONFIG_SPL_BUILD))
+ /* Set vector address in CP15 VBAR register */
+ ldr r0, =_start
+ add r0, r0, r9
+ mcr p15, 0, r0, c12, c0, 0 @Set VBAR
+#endif
+#endif /* !Tegra2 */
+
ldr r0, _board_init_r_ofs
adr r1, _start
add lr, r0, r1
I think this code should get boot tested on a few platforms to make sure
it's OK. As such, I've tried on am335x and omap3 and they're still
fine.
Tested-by: Tom Rini<tr...@ti.com>
Tom, thank you for testing.
Easy way to test this patch.
Jump any bad address using go command on U-boot prompt.
Good restult:
> go 0x0badc0de
## Starting application at 0x0BADC0DE ...
undefined instruction
pc : [<0badc0e0>] lr : [<5ff91354>]
sp : 5feefb98 ip : 0000001c fp : 5feefbdd
r10: 00000002 r9 : 5feefbdd r8 : 5feeff68
r7 : 5feeff14 r6 : 0badc0de r5 : 5feefed4 r4 : 00000002
r3 : 0badc0de r2 : 5feefed4 r1 : 5feefed4 r0 : 00000001
Flags: nZCv IRQs off FIQs off Mode SVC_32
Resetting CPU ...
resetting ...
Bad result:
> go 0x0badc0de
(.. hang up without any crash dump.)
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot