On 08/03/2012 12:32 PM, Mathieu Poirier wrote: > Thanks for the review - see my comments below. > > Mathieu. > > On 12-08-03 08:46 AM, Tom Rini wrote: >> On Tue, Jul 31, 2012 at 12:59:23PM -0600, mathieu.poir...@linaro.org wrote: >> >>> From: "Mathieu J. Poirier" <mathieu.poir...@linaro.org> >>> >>> Signed-off-by: Mathieu Poirier <mathieu.poir...@linaro.org> >>> Signed-off-by: John Rigby <john.ri...@linaro.org> >> [snip] >>> +++ b/board/st-ericsson/snowball/Makefile >> [snip] >>> +#prcmu.o >> >> Drop please. >> >> [snip] >>> +++ b/board/st-ericsson/snowball/snowball.c >>> +int dram_init(void) >>> +{ >>> + uint32_t unused_cols_rows; >>> + unsigned int nrows; >>> + unsigned int ncols; >>> + >>> + gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE; >>> + gd->ram_size = PHYS_SDRAM_SIZE_1; >>> + >>> + /* >>> + * Assumption: 2 CS active, both CS have same layout. >>> + * 15 rows max, 11 cols max (controller spec). >>> + * memory chip has 8 banks, I/O width 32 bit. >>> + * The correct way would be to read MR#8: I/O width and density, >>> + * but this requires locking against the PRCMU firmware. >>> + * Simplified approach: >>> + * Read number of unused rows and columns from mem controller. >>> + * size = nCS x 2^(rows+cols) x nbanks x buswidth_bytes >>> + */ >>> + unused_cols_rows = readl(DMC_CTL_97); >>> + nrows = 15 - (unused_cols_rows & 0x07); >>> + ncols = 11 - ((unused_cols_rows & 0x0700) >> 8); >>> + gd->ram_size = gd->bd->bi_dram[0].size = >>> + 2 * (1 << (nrows + ncols)) * 8 * 4; >> >> Please use get_mem_size(CONFIG_SYS_SDRAM_BASE, possible-max-size) (and >> defining CONFIG_SYS_MAX_RAM_SIZE is common convention) instead of all >> the above. >> > > Is 'get_mem_size' supposed to be an existing API ? I grep'ed for it in > the code to no avail.
Arg, sorry, mental error. get_ram_size is the right one. -- Tom _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot