Am 17/08/2012 20:15, schrieb Matt Sealey:
> Use calloc() instead of malloc() to allocate the mxc_spi_slave structure.
> Clearing the memory is necessary since most of the time this gets done
> super early in boot, but on warm reboots, and when SPI probing is done
> long after the init stages it could actually pick up previously used memory,
> and things like the chipselect polarity and other data end up being filled
> with trash data if not explicitly set by the board files.
>
> This solves a semi-random, almost unreproducable error whereby SPI devices
> act very, very strangly on boot. Tested on Efika MX over several years..
>
> Signed-off-by: Matt Sealey <m...@genesi-usa.com>
> ---
> drivers/spi/mxc_spi.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/spi/mxc_spi.c b/drivers/spi/mxc_spi.c
> index 2e15318..d1dab18 100644
> --- a/drivers/spi/mxc_spi.c
> +++ b/drivers/spi/mxc_spi.c
> @@ -408,7 +408,7 @@ struct spi_slave *spi_setup_slave(unsigned int bus,
> unsigned int cs,
> if (bus >= ARRAY_SIZE(spi_bases))
> return NULL;
>
> - mxcs = malloc(sizeof(struct mxc_spi_slave));
> + mxcs = calloc(sizeof(struct mxc_spi_slave), 1);
> if (!mxcs) {
> puts("mxc_spi: SPI Slave not allocated !\n");
> return NULL;
>
Agree, the structure must be zeroed.
Acked-by: Stefano Babic <sba...@denx.de>
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
