Am 19/08/2012 00:29, schrieb Marek Vasut: > Dear Matt Sealey, > >> On Sat, Aug 18, 2012 at 10:34 AM, Stefano Babic <sba...@denx.de> wrote: >>> On 17/08/2012 20:19, Matt Sealey wrote: >>>> The i.MX Boot ROM lets us set up certain registers before U-Boot even >>>> gets executed. Rather than setting up DDR, putting U-Boot in place, and >>>> getting into pre-relocation init to set up DDR again, just do it once >>>> in the correct place. This also solves an issue where the Smarttop DDR >>>> pad settings were being applied on Smartbook. >>>> >>>> While we're at it, configure PCBID0,1,2 and the LED GPIO since we've >>>> still got room in the DCD to do so. >>>> >>>> Signed-off-by: Matt Sealey <m...@genesi-usa.com> >>>> --- >>> >>> Hi Matt, >>> >>>> diff --git a/board/genesi/mx51_efikamx/imximage_mx.cfg >>>> b/board/genesi/mx51_efikamx/imximage_mx.cfg index 6fe0ff9..ac9aa9a >>>> 100644 >>>> --- a/board/genesi/mx51_efikamx/imximage_mx.cfg >>>> +++ b/board/genesi/mx51_efikamx/imximage_mx.cfg >>>> @@ -1,7 +1,7 @@ >>>> >>>> # >>>> >>>> +# Copyright (C) 2009 Pegatron Corporation >>>> >>> ^--- >>> >>> Was this added for mistake ? I think you should add only yours. >> >> The drive strength settings came from Pegatron a long, long time ago >> (2009 :) and our old config and the function is copyrighted to them. >> Just because Marek took them out and recopyrighted the file I derived >> them from in this case doesn't mean they lost their copyright.. > > This file was taken from mx51evk. It's written there. Please stop this > nonsense, > it's troubling me.
Then Pegatron has nothing to do with it. The original comes from Freescale, and the copyright was set. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot