Am 13/09/2012 06:55, schrieb Fabio Estevam: > Hi Stefano, > > On Wed, Sep 12, 2012 at 6:44 PM, stefano babic <sba...@denx.de> wrote: > >> U-Boot for mx35pdk runs from NOR and not from NAND. There is no support >> to run from NAND. Even if I can "convince" the board to boot from NAND, >> this was not pushed to mainline. I explain why. > > Reading board/freescale/mx35pdk/README it gives the impression that > booting from NAND is supported.
It is a wrong impression, it is not (yet) supported.. > > Should this be updated? Yes ! Regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot