I understand the advantage of the tool when installed on a PC. But not the advantage of adding it to Uboot, since the tool is needed when Uboot is broken and doesn't work anymore. How would you use this tool from within Uboot, if you can't access Uboot prompt? :) And if you can access the prompt, then you can reflash Uboot or change its environment without this tool.
On 11/10/12, Prafulla Wadaskar <prafu...@marvell.com> wrote: > > >> -----Original Message----- >> From: u-boot-boun...@lists.denx.de [mailto:u-boot- >> boun...@lists.denx.de] On Behalf Of Sambul >> Sent: 04 November 2012 18:28 >> To: u-boot@lists.denx.de >> Subject: Re: [U-Boot] kwboot: Boot Marvell Kirkwood SoCs over a serial >> link. >> >> Wolfgang Denk <wd <at> denx.de> writes: >> >> > >> > Please see http://www.denx.de/wiki/U-Boot/Patches and post proper >> > patch(es). >> > >> > Thanks. >> > >> > Best regards, >> > >> > Wolfgang Denk >> > >> >> I assume that tool is needed to boot a Plug via Serial instead of >> using more >> complex Jtag restore of Uboot, when Uboot is broken. So, what's the >> advantage of >> adding this tool to Uboot? > > Answer is within your question, let's say someone don't have jtag tool, and > bricked the board, this tool enables to bring up board back to functional > state (just need a serial console). > > Actually it can be used effectively for new board bring up without using > JTAG. > > Regards... > Prafulla . . . > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
