I used to be running 11.10 ubuntu server on a Jetway NC9C-550-LF with the ADPE4S-LF daughter board.
11.10 server was never able to see my drives, so i had hoped that upgrading to 12.04 would provide me with a linux operating system that would be able to see my 4 2tb drives and thus allow me to use ZFS. It does not. $ sudo lspci -v 06:00.0 RAID bus controller: Marvell Technology Group Ltd. 88SE6145 SATA II PCI-E controller (rev a1) Subsystem: Marvell Technology Group Ltd. 88SE6145 SATA II PCI-E controller Flags: bus master, fast devsel, latency 0, IRQ 10 I/O ports at e480 [size=8] I/O ports at e400 [size=4] I/O ports at ec00 [size=8] I/O ports at e880 [size=4] I/O ports at e800 [size=16] Memory at febbfc00 (32-bit, non-prefetchable) [size=1K] Expansion ROM at febc0000 [disabled] [size=256K] Capabilities: [48] Power Management version 2 Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit- Capabilities: [e0] Express Legacy Endpoint, MSI 00 Kernel modules: pata_marvell I have 4 2tb drives attached to it. The bios sees those 4 drives. Ubuntu does not : $ sudo fdisk -l Disk /dev/sda: 1000.2 GB, 1000204886016 bytes 255 heads, 63 sectors/track, 121601 cylinders, total 1953525168 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x000c0804 Device Boot Start End Blocks Id System /dev/sda1 63 1953520064 976760001 83 Linux Disk /dev/sdb: 80.1 GB, 80060424192 bytes 255 heads, 63 sectors/track, 9733 cylinders, total 156368016 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x560f0366 Device Boot Start End Blocks Id System /dev/sdb1 * 63 40965749 20482843+ 83 Linux /dev/sdb2 40965750 43022069 1028160 82 Linux swap / Solaris /dev/sdb3 43022070 156360644 56669287+ 83 Linux Disk /dev/sdc: 2000.4 GB, 2000398843904 bytes 255 heads, 63 sectors/track, 243201 cylinders, total 3907028992 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x0f93b9cb Device Boot Start End Blocks Id System /dev/sdc1 63 3907024064 1953512001 83 Linux what you see there is my: - 1tb internal drive - 80g system drive - 2tb external usb drive what you don't see there is my : - 4 2tb internal drives attached to the sata raid daughter board. if you need me to paste some more terminal output please let me know what it is. -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/463242 Title: Marvell 88SE6145 SATA II PCI-E controller not recognized by sata_mv.ko To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux/+bug/463242/+subscriptions -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs