reinstalling proprietor driver results in recovery of trip_pont 69000 and "sensors" detect after cooling lower temperature than 68°C (65) increasing fan speed at 76°C 84°C 86,5°C ??? (cannot even guess where this one came from)
i do not believe that any of the temperatures are correct because heat build up and cooling are too quick nevertheless proprietor driver has to go After removal of proprietor driver fan speeds increase at 74°C 84°C decrease at 79.5°C and after a long time (guess 7min) at 69°C to lowest speed according to dsmeg fan is registered as cooling device 7 /sys/bus/acpi/devices/device:07/subsystem/drivers/fan/PNP0C0B:00/thermal_cooling/subsystem/thermal_zone0 trip_points registered there are the same as in /sys/bus/acpi/drivers/thermal/LNXTHERM:01/thermal_zone 48000 57000 75000 84000 92000 100000 Since I am not fluent with any programming stuff i can only guess what happens. There is a routine accessing and altering values that it should not alter. There is one sensor and one fan on my hp 625 and it is using values from hwmon. Additional, altering the drivers results in changing sensor values and trip points. Though the routine doing all this rubbish has to be connected to this process. Whatever it is, it is altering setup procedures because only after restart the system is affected. God am I happy that my cpu has only 55W. To my understanding there should not be any routine overriding those values. I will repeat the procedure and compare dsmeg reports. If i find anything i post it here. Thanks and best regards to all M.Peters -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/960925 Title: cpu resources divided to graphic driver To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/acpid/+bug/960925/+subscriptions -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs