Schily wrote: > If you have problems with burning the data you should send the output > from cdrecord -v to allow to understand what happened. > Your website says you no longer have time to provide support, which I very much understand. So thanks very much for your offer of assistance. Here is the output.
> [EMAIL PROTECTED]:/opt/schily/bin$ sudo ./cdrecord -v dev=1000,1,0 -speed=2 > ~/dvd.iso > ./cdrecord: No write mode specified. > ./cdrecord: Asuming -sao mode. > ./cdrecord: If your drive does not accept -sao, try -tao. > ./cdrecord: Future versions of cdrecord may have different drive dependent > defaults. > Cdrecord-ProDVD-ProBD-Clone 2.01.01a35 (powerpc-unknown-linux-gnu) Copyright > (C) 1995-2007 J�rg Schilling > TOC Type: 1 = CD-ROM > scsidev: '1000,1,0' > scsibus: 1000 target: 1 lun: 0 > Linux sg driver version: 3.5.27 > Using libscg version 'schily-0.9'. > SCSI buffer size: 64512 > atapi: 1 > Device type : Removable CD-ROM > Version : 0 > Response Format: 2 > Capabilities : > Vendor_info : 'MATSHITA' > Identifikation : 'DVD-R UJ-835F ' > Revision : 'GGND' > Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM. > Current: DVD+R > Profile: DVD+R (current) > Profile: DVD+RW > Profile: DVD-RW restricted overwrite > Profile: DVD-RW sequential recording > Profile: DVD-R sequential recording > Profile: DVD-ROM > Profile: CD-RW > Profile: CD-R > Profile: CD-ROM > Using generic SCSI-3/mmc-3 DVD+R driver (mmc_dvdplusr). > Driver flags : NO-CD DVD MMC-3 SWABAUDIO BURNFREE > Supported modes: PACKET SAO > Drive buf size : 1572864 = 1536 KB > FIFO size : 4194304 = 4096 KB > Track 01: data 4479 MB > Total size: 4479 MB = 2293754 sectors > Current Secsize: 2048 > Blocks total: 2295104 Blocks current: 2295104 Blocks remaining: 1350 > Starting to write CD/DVD/BD at speed 2 in real SAO mode for single session. > Last chance to quit, starting real write 0 seconds. Operation starts. > Waiting for reader process to fill input buffer ... input buffer ready. > Starting new track at sector: 0 > Track 01: 3685 of 4479 MB written (fifo 98%) [buf 98%] 2.5x../cdrecord: > Success. write_g1: scsi sendcmd: no error > CDB: 2A 00 00 1C CB 38 00 00 1F 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: F1 00 04 00 1C C8 40 0A 00 39 00 00 03 03 00 00 > Sense Key: 0x4 Hardware Error, deferred error, Segment 0 > Sense Code: 0x03 Qual 0x03 (peripheral device write fault) [No matching > qualifier] Fru 0x0 > Sense flags: Blk 1886272 (valid) > resid: 63488 > cmd finished after 3.406s timeout 100s > > write track data: error after 3864641536 bytes > ./cdrecord: A write error occured. > ./cdrecord: Please properly read the error message above. > Writing time: 1238.342s > Average write speed 2.7x. > Min drive buffer fill was 16% > Fixating... > ./cdrecord: Success. close track/session: scsi sendcmd: no error > CDB: 5B 01 01 00 00 01 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 05 00 00 00 00 0A 00 83 00 00 30 05 00 00 > Sense Key: 0x5 Illegal Request, Segment 0 > Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 0.002s timeout 1000s > ./cdrecord: Success. close track/session: scsi sendcmd: no error > CDB: 5B 01 01 00 00 01 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 05 00 00 00 00 0A 00 83 00 00 30 05 00 00 > Sense Key: 0x5 Illegal Request, Segment 0 > Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 0.002s timeout 1000s > cmd finished after 0.002s timeout 1000s > Trouble closing the track > ./cdrecord: Success. close track/session: scsi sendcmd: no error > CDB: 5B 01 06 00 00 00 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 05 00 00 00 00 0A 00 83 00 00 30 05 00 00 > Sense Key: 0x5 Illegal Request, Segment 0 > Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 0.002s timeout 1000s > ./cdrecord: Success. close track/session: scsi sendcmd: no error > CDB: 5B 01 06 00 00 00 00 00 00 00 > status: 0x2 (CHECK CONDITION) > Sense Bytes: 70 00 05 00 00 00 00 0A 00 83 00 00 30 05 00 00 > Sense Key: 0x5 Illegal Request, Segment 0 > Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0 > Sense flags: Blk 0 (not valid) > cmd finished after 0.002s timeout 1000s > cmd finished after 0.002s timeout 1000s > Trouble closing the last session > Fixating time: 0.007s > ./cdrecord: fifo had 60936 puts and 60873 gets. > ./cdrecord: fifo was 0 times empty and 46781 times full, min fill was 81%. > [EMAIL PROTECTED]:/opt/schily/bin$ -- mkisofs can't handle files over 2^32 bytes https://bugs.launchpad.net/bugs/30033 You received this bug notification because you are a member of Ubuntu Bugs, which is a direct subscriber. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
