ddc probe finds the resolutions for my monitor, but not for my graphics chip?
sudo ddcprobe Password: vbe: VESA 3.0 detected. oem: NVIDIA vendor: NVIDIA Corporation product: CR17 Board Chip Rev A3 memory: 32768kb mode: 640x400x256 mode: 640x480x256 mode: 800x600x16 mode: 800x600x256 mode: 320x200x64k mode: 320x200x16m mode: 640x480x64k mode: 640x480x16m mode: 800x600x64k mode: 800x600x16m edid: edid: 1 3 id: a001 eisa: DELa001 serial: 38315a42 manufacture: 11 2002 input: sync on green, analog signal. screensize: 31 23 gamma: 2.900000 dpms: RGB, active off, suspend, standby timing: [EMAIL PROTECTED] Hz (VGA) timing: [EMAIL PROTECTED] Hz (VESA) timing: [EMAIL PROTECTED] Hz (VESA) timing: [EMAIL PROTECTED] Hz (VESA) timing: [EMAIL PROTECTED] Hz (VESA) ctiming: [EMAIL PROTECTED] ctiming: [EMAIL PROTECTED] ctiming: [EMAIL PROTECTED] ctiming: [EMAIL PROTECTED] dtiming: [EMAIL PROTECTED] monitorserial: 23DDC23B81ZB monitorname: DELL E771a monitorrange: 30-70, 50-160 It's an onboard nvidia gforce chip (think mx4) and an old dell crt. I am now running at 1024x768 but only by manually adding the monitor ranges to xorg.conf -- Xorg resolution falling back to 640x480 and/or 800x600 when h/v freqs incorrect https://bugs.launchpad.net/bugs/3731 You received this bug notification because you are a member of Kubuntu Team, which is a subscriber of a duplicate bug. -- kubuntu-bugs mailing list [EMAIL PROTECTED] https://lists.ubuntu.com/mailman/listinfo/kubuntu-bugs