When I rmmod the module, I get this on dmesg:
[145624.216000] pccard: CardBus card inserted into slot 0 [145624.420000] rtl_ieee80211_crypt: registered algorithm 'NULL' [145624.420000] rtl_ieee80211_crypt: registered algorithm 'TKIP' [145624.420000] rtl_ieee80211_crypt: registered algorithm 'WEP' [145624.420000] rtl_ieee80211_crypt: registered algorithm 'CCMP' [145624.488000] [145624.488000] Linux kernel driver for RTL8180 / RTL8185 based WLAN cards [145624.488000] Copyright (c) 2004-2005, Andrea Merello [145624.488000] rtl8180: Initializing module [145624.488000] rtl8180: Wireless extensions version 22 [145624.488000] rtl8180: Initializing proc filesystem [145624.492000] rtl8180: Configuring chip resources [145624.492000] PCI: Enabling device 0000:03:00.0 (0000 -> 0003) [145624.492000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 [145624.492000] PCI: Setting latency timer of device 0000:03:00.0 to 64 [145624.492000] rtl8180: Memory mapped space @ 0xd4000000 [145624.492000] rtl8180: MAC controller is a RTL8180 [145624.492000] rtl8180: This is a CARDBUS NIC [145624.492000] rtl8180: Reported EEPROM chip is a 93c56 (2Kbit) [145624.500000] rtl8180: Card MAC address is 00:09:5b:22:02:c4 [145624.508000] rtl8180: EEPROM version 102 [145624.508000] rtl8180: RfParam: 5 [145624.512000] rtl8180: Card reports RF frontend by Philips. [145624.512000] rtl8180: OK! Philips SA2400 radio chipset is supported. [145624.512000] rtl8180: Analog PHY found [145624.512000] rtl8180: Energy threshold: b [145624.512000] rtl8180: PAPE from CONFIG2: 6 [145624.512000] rtl8180: Antenna A is default antenna [145624.512000] rtl8180: Antenna diversity is enabled [145624.512000] rtl8180: Carrier sense 1 [145624.512000] rtl8180: 40-bit WEP is NOT supported in hardware [145624.512000] rtl8180: 104-bit WEP is NOT supported in hardware [145624.516000] rtl8180: IRQ 11 [145624.516000] rtl8180: Driver probe completed [145624.516000] [145633.492000] rtl8180: Card successfully reset [145633.712000] rtl8180: Freeing irq 11 [145633.716000] ACPI: PCI interrupt for device 0000:03:00.0 disabled [145633.716000] rtl8180: wlan driver removed [145633.716000] [145633.716000] WARNING: at /build/buildd/linux-source-2.6.22-2.6.22/fs/proc/generic.c:741 remove_proc_entry() [145633.716000] [<c01b8585>] remove_proc_entry+0x1a5/0x1b0 [145633.716000] [<f8b70362>] rtl8180_pci_module_exit+0x12/0x22 [r8180] [145633.716000] [<c014c1da>] sys_delete_module+0x12a/0x190 [145633.716000] [<c02f0030>] clip_constructor+0x20/0xa0 [145633.716000] [<c016f9d6>] do_munmap+0x186/0x1e0 [145633.716000] [<c01041d2>] sysenter_past_esp+0x6b/0xa9 [145633.716000] [<c02f0000>] clip_ioctl+0x500/0x510 [145633.716000] ======================= [145633.716000] rtl8180: Exiting -- r818x driver freezes randomly https://bugs.launchpad.net/bugs/31857 You received this bug notification because you are a member of Ubuntu Bugs, which is a direct subscriber. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs