> lxc.net.0.ipv4.gateway = 192.168.252.1
> lxc.net.0.ipv4.address = 192.168.252.171/32
> 3. inside the container, deactivate dhcp (dhcp4: false )in
`/etc/netplan/10-lxc.yaml`,
ok, this is your problem; you're misconfiguring the instance.
Unfortunately, you were just 'lucky' that it worked before, but this is
absolutely intended behavior of systemd: when you tell it to manage an
interface, it expects to control 100% of the interface's addresses and
routing (with the minor exception that newer systemd has added
'KeepConfiguration' config for specific situations where externally-
configured networking should be kept on the interface, such as some HA
setups).
Your problem here is that you're configuring the interface networking
*outside* networkd, but then also telling networkd it should manage the
interface. It's fine to use lxc to externally configure the interface
networking, but then inside the container you must make sure networkd
does not think it's managing eth0, which means you must completely
remove the 'eth0' section inside the netplan config yaml - if you leave
any 'eth0' config there at all, it will create a network file telling
networkd that it should manage eth0, even though it's not assigning any
ipv4 addresses (it does setup ipv6 link-local by default, however). The
file that netplan creates for the eth0 interface will be
/run/systemd/network/10-netplan-eth0.network.
You can see in the output of networkctl:
root@bionic:/# networkctl list
IDX LINK TYPE OPERATIONAL SETUP
1 lo loopback carrier unmanaged
29 eth0 ether degraded configured
since in your use case you do not use (or want!) networkd to manage
eth0, you want the 'SETUP' column to show 'unmanaged', not 'configured'.
What you need to do is, instead of simply changing the netplan eth0
dhcp4 configuration to false, you need to remove the eth0 section
completely. If that's the only section you have, you'll need to remove
the entire 'ethernets' section, or just remove the yaml file entirely
(or rename it to anything that doesn't end in '.yaml').
Then, when you 'netplan apply' or reboot, you should notice that the
/run/systemd/network/ file for eth0 is no longer created, and networkd
no longer thinks it manages eth0, and your externally-configured eth0
networking should work again.
I hope this works for you, and very sorry for the disruption of your
production environment.
** Changed in: systemd (Ubuntu)
Status: Incomplete => Invalid
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1863873
Title:
Systemd fails to configure bridged network in LXC container
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/systemd/+bug/1863873/+subscriptions
--
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
