** Description changed: - Upstream raspberrypi patchset 2021-05-28 - Ported from the following raspberrypi branch: - rpi-5.12.y - from https://github.com/raspberrypi/linux.git + Ported from the following raspberrypi branch: + rpi-5.12.y + from https://github.com/raspberrypi/linux.git + + overlays: Add rpi-poe-plus overlay + configs: Enable Raspberry Pi PoE+ HAT support + Add Raspberry Pi PoE+ HAT support + configs: add bh1750 and ccs811 to configs (#4334) + overlays: add bh1750 and ccs811 to i2c-sensor (#4334) + configs: Add GPIO_PCA953X_IRQ=y + overlays: Remove deleted merus-amp parameter + configs: Add CONFIG_SENSIRION_SGP30=m + overlays: add sensirion sgp30 to i2c-sensor overlay + Add CAN_J1939 as module to default build configs (#4346) + media: rpivid: Improve SPS/PPS error handling/validation + media: rpivid: Improve stream_on/off conformance & clock setup + media: rpivid: Improve values returned when setting output format + media: rpivid: Map cmd buffer directly + Revert "media: v4l2-mem2mem: allow request job buffer processing after job finish" + media: rpivid: Add a Pass0 to accumulate slices and rework job finish + RFC: media: Add media_request_{pin,unpin} API + media: rpivid: Add an enable count to irq claim Qs + media: rpivid: Convert to MPLANE + media: rpivid: Remove the need to have num_entry_points set + dtoverlays: Update /__symbols__/i2c0 from i2c0 overlay + dtoverlays: Add pinctrl-names to i2c0 overlay. + media: i2c: ov5647: Fix v4l2-compliance failure subscribing to events + media: i2c: ov5647: Correct minimum VBLANK value + media: i2c: ov5647: Correct pixel array offset + configs: Add NF_LOG_ARP=m and NF_LOG_NETDEV=m + overlays: merus-amp: remove spi override + vc4/drm: hdmi: Fix missing declaration + drm/vc4: hdmi: Add a workqueue to set scrambling + drm/vc4: hdmi: Rely on interrupts to handle hotplug + drm/vc4: hdmi: Simplify the connector state retrieval + drm/vc4: hdmi: Make sure the controller is powered in detect + drm/vc4: hdmi: Switch to pm_runtime_resume_and_get + drm/vc4: crtc: Lookup the encoder from the register at boot + drm/vc4: crtc: Fix vc4_get_crtc_encoder logic + drm/vc4: crtc: Pass the drm_atomic_state to config_pv + Revert "drm/vc4: Rework the encoder retrieval code" + clk: Always clamp the rounded rate + configs: add CONFIG_QCA7000_UART=m (#4322) + configs: Regenerate defconfigs + spi: bcm2835: Increase the CS limit to 24 + ARM: dts: bcm2711-rpi-400: Limit MDIO clock speed + drm/vc4: Allow DBLCLK modes even if horz timing is odd. + gpio-poweroff: Remember the old poweroff handler + overlays: Add ugreen-dabboard overlay + overlays: README - improve the gpio-poweroff guide + overlays: Allow multiple gpio-shutdown instances + staging/bcm2835-isp: Fix compiler warning + staging/bcm2835-codec: Do not update crop from S_FMT after res change + staging/bcm2835-camera: Add support for H264 levels 4.1 and 4.2 + staging/bcm2835-codec: Pass corrupt frame flag. + staging/bcm2835-codec: Set the colourspace appropriately for RGB formats + staging/bcm2835-codec: Fix support for levels 4.1 and 4.2 + clk: requests: Dereference the request pointer after the check + configs: Enable ATA and AHCI for SATA drive support. + drm/vc4: Separate VEC compatible variants + drm/vc4: Fix clock source for VEC PixelValve on BCM2711 + drm/vc4: Fix VEC address for BCM2711 in the devicetrees + overlays: spi-rtc: Add ds3232 and ds3234 + vc4/drm: hdmi: Handle case when bvb clock is null + drm/vc4: hdmi: Raise the maximum clock rate + drm/vc4: hdmi: Enable the scrambler + drm/vc4: hdmi: Check and warn if we can't reach 4kp60 frequencies + drm/vc4: hdmi: Properly compute the BVB clock rate + drm/vc4: hvs: Make the HVS bind first + drm/vc4: hdmi: Prevent clock unbalance + drm/vc4: Rework the encoder retrieval code + drm/vc4: crtc: Skip the TXP + drm/vc4: txp: Properly set the possible_crtcs mask + clk: requests: Ignore if the pointer is null + dtoverlays: Add overlays for JDI LT070ME05000 1200x1920 DSI panel + defconfigs: Add PANEL_JDI_LT070ME05000 DSI panel + drm/panel: jdi-lt070me05000: Use gpiod_set_value_cansleep + drm/atomic: Don't fixup modes that haven't been reset + drm/vc4: Add correct stop condition to vc4_dsi_encoder_disable iteration + drm/vc4: Fix dsi0 interrupt support. + drm/vc4: Register dsi0 as the correct vc4 encoder type + drm/vc4: Correct pixel order for DSI0 + dwc_otg: fix an undeclared variable + rpivid: Only clk_request_done once + rpivid: Switch to new clock api + bcm2835-unicam: Switch to new clock api + drm/vc4: hdmi: Convert to the new clock request API + drm/vc4: hdmi: Convert to the new clock request API + clk: Introduce a clock request API + overlays: ghost-amp: Add DAC mute control + sound/usb: call usb_autopm_get_interface() for devices that should not + sound/usb: add device quirks for A4Tech FHD 1080p webcams + vc4/kms: vc4_plane: Support 2020 colourspace for yuv planes + staging: vcsm-cma: Fix memory leak from not detaching dmabuf + drm/vc4: hdmi: Signal the proper colorimetry info in the infoframe + drm/connector: Add a helper to attach the colorspace property + drm/vc4: Use the new helpers + drm/connector: Add helper to compare HDR metadata + drm/connector: Create a helper to attach the hdr_output_metadata property
-- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/1930365 Title: impish/linux-raspi: Upstream raspberrypi patchset 2021-05-28 To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux-raspi/+bug/1930365/+subscriptions -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
