Public bug reported:

Title: System hard-freezes during Software Updater installation on ASUS
ExpertBook B1502CBA – Intel i915 / DMAR DMA faults

System Information

OS: Ubuntu 26.04 LTS Desktop
Desktop Environment: GNOME on Wayland
Kernel: 7.0.0-44-generic
Hardware: ASUS ExpertBook B1502CBA
CPU: 13th Gen Intel Core i3
GPU: Intel Integrated Graphics (PCI ID: 00:02.0)
Graphics Driver: i915
RAM: 12 GB
Swap: 12 GB swapfile
Storage: 512 GB NVMe SSD
Intel VT-d / DMAR: Enabled
Incident Date: November 21, 2026
Incident Time: Approximately 12:52 PM (+0530)
1. Bug Description

The system experiences a complete hard lock during GUI-based system
updates using Ubuntu Software Updater (update-manager).

During the installation of pending updates, the graphical desktop
becomes completely unresponsive. The mouse, keyboard, virtual terminal
switching, and hardware Caps Lock LED stop responding.

The issue appears to occur repeatedly on this hardware when installing
system updates through update-manager.

During the latest incident, the update process stopped displaying
progress at:

Setting up snapd (2.76+ubuntu26.04) ...

The system subsequently became completely unresponsive.

2. Steps to Reproduce
Boot Ubuntu 26.04 LTS on an ASUS ExpertBook B1502CBA.
Use the GNOME desktop session running on Wayland.
Leave the system idle without foreground applications.
Launch Software Updater (update-manager).
Install pending system updates.
During the installation, allow dpkg to configure packages including snapd, 
ubuntu-drivers-common, and kernel-related packages.
Observe the system when the update process reaches the snapd configuration 
stage.

Observed result: The entire system freezes, requiring Magic SysRq
recovery or a forced reboot.

Expected result: System updates should complete normally without causing
a complete system lockup. The desktop should remain responsive or
recover gracefully during package configuration and service restarts.

3. Actual Behaviour and Symptoms

During the incident:

GNOME desktop completely froze.
Top-panel clock stopped updating at approximately 12:52:21 PM.
System monitor indicators also stopped updating.
Last displayed system monitor values:
CPU: 13%
Memory: 29%
Swap: 0%
Load: 32% (2.6)
GPU: 33%
Mouse cursor and keyboard input became unresponsive.
Ctrl+Alt+F3 did not switch to a virtual terminal.
Ctrl+Alt+Fn+F4 and Ctrl+Alt+Fn+F5 also failed.
Caps Lock did not toggle the physical keyboard LED.
NVMe disk activity LED remained continuously illuminated without visible 
blinking.

The failure appears to be more severe than a normal GNOME Shell or
application freeze because virtual terminal switching and keyboard LED
response were also unavailable.

4. Relevant Kernel Log Errors

Inspection of the previous boot's kernel logs using:

journalctl -b -1 -p 3 --no-pager | tail -n 20

revealed the following errors:

Intel DMAR / IOMMU DMA fault:

DMAR: [DMA Read NO_PASID] Request device [00:02.0] fault addr 0xe100a000
[fault reason 0x06] PTE Read access is not set

Intel i915 graphics driver error:

i915 0000:00:02.0: [drm] *ERROR* Initial plane programming using invalid
range, dma_addr=0x00000000e1000000

Both errors reference the Intel integrated graphics device at PCI
address 00:02.0.

These messages suggest a possible Intel IOMMU DMA mapping issue
involving the i915 graphics driver.

It is currently unknown whether these errors directly trigger the
system-wide lockup or are symptoms of another underlying kernel or
graphics driver issue.

5. Packages Being Installed During the Incident

The update process had unpacked the following packages before the system
became unresponsive:

linux-tools-7.0.0-44-generic
plasma-desktoptheme
python3-software-properties
ubuntu-drivers-common
snapd (2.76+ubuntu26.04)
microsoft-edge-stable

The last visible package configuration message was:

Setting up snapd (2.76+ubuntu26.04) ...

It is not yet confirmed whether snapd configuration is directly
responsible for triggering the issue.

6. Recovery Procedure

Magic SysRq successfully recovered the system.

The following sequence was executed:

Alt + PrtSc + R
Alt + PrtSc + E
Alt + PrtSc + I
Alt + PrtSc + S
Alt + PrtSc + U
Alt + PrtSc + B

The machine rebooted successfully and returned to the GDM login screen.

After logging in, the interrupted package configuration was repaired
using:

sudo dpkg --configure -a

Then the following commands were executed:

sudo apt --fix-broken install && sudo apt update && sudo apt full-
upgrade -y && sudo snap refresh

Finally, the running kernel and graphics module were checked using:

uname -r && lsmod | grep i915

All interrupted packages, including snapd, linux-tools-7.0.0-44-generic,
and microsoft-edge-stable, were configured successfully without reported
package errors.

The i915 kernel module loaded normally after reboot.

7. Possible Cause / Technical Investigation

The primary suspected issue is an interaction between Intel integrated
graphics, Intel VT-d/IOMMU DMA remapping, and the i915 driver.

The DMAR error reports a DMA Read NO_PASID fault involving the
integrated GPU, with a page-table entry that does not permit read
access.

The i915 driver also reports an invalid DMA address range during initial
display-plane programming.

A possible kernel regression or incompatibility involving Intel
integrated graphics and IOMMU DMA mappings could explain the system-
level freeze.

Another possibility is that package configuration and service restarts
during update-manager expose an existing graphics driver or kernel
issue.

However, no direct evidence currently establishes that snapd, AppArmor,
desktop portals, or GNOME Wayland independently cause the failure.

Further investigation is required to identify the exact trigger.

8. Potential Workarounds (Not Yet Tested)

A. Disable IOMMU specifically for Intel integrated graphics

Proposed kernel parameter:

intel_iommu=igfx_off

This has not yet been tested.

B. Avoid GUI-based updates

Proposed alternative:

sudo apt update && sudo apt full-upgrade -y && sudo snap refresh

This has not yet been established as a permanent workaround.

C. Enable the full Magic SysRq functionality

Proposed configuration:

kernel.sysrq = 1

To be configured in /etc/sysctl.d/99-sysrq.conf.

This has not yet been tested.

9. Current Status
System recovered successfully using Magic SysRq.
Interrupted package configuration completed successfully.
No remaining package configuration errors were observed.
Intel i915 module loaded normally after reboot.
Previous boot's journal contains DMAR and i915 errors.
IOMMU is still enabled.
No kernel boot parameters have been modified.
The underlying cause remains unconfirmed.
10. Assistance Requested

I would appreciate investigation into the following:

Whether this is a known Intel i915 / VT-d / DMAR issue affecting 13th Gen Intel 
integrated graphics.
Whether kernel 7.0.0-44-generic contains a regression affecting Intel graphics 
DMA mappings or display-plane programming.
Whether the reported DMA Read NO_PASID fault and invalid i915 DMA address range 
can cause a complete system-wide lockup.
Whether there are known fixes or patches available in newer upstream kernel or 
i915 versions.
Whether additional kernel debugging, DRM debugging, or IOMMU diagnostic 
information would help identify the root cause.

The main concern is that the entire operating system becomes
unresponsive, including virtual terminal switching and keyboard hardware
LED response, during routine GUI-driven package updates. This is a
recurring reliability issue on the affected hardware.

ProblemType: Bug
DistroRelease: Ubuntu 26.04
Package: ubuntu-release-upgrader-core 1:26.04.27
ProcVersionSignature: Ubuntu 7.0.0-44.44-generic 7.0.14
Uname: Linux 7.0.0-44-generic x86_64
ApportVersion: 2.34.1-0ubuntu0.1
Architecture: amd64
CasperMD5CheckResult: pass
CrashDB: ubuntu
CurrentDesktop: ubuntu:GNOME
Date: Sat Nov 21 13:43:15 2026
InstallationDate: Installed on 2026-09-18 (64 days ago)
InstallationMedia: Ubuntu 26.04.1 LTS "Resolute Raccoon" - Release amd64 
(20260826)
PackageArchitecture: all
ProcEnviron:
 LANG=en_US.UTF-8
 PATH=(custom, no user)
 SHELL=/bin/bash
 TERM=xterm-256color
 XDG_RUNTIME_DIR=<set>
SourcePackage: ubuntu-release-upgrader
Symptom: ubuntu-release-upgrader
UpgradeStatus: No upgrade log present (probably fresh install)

** Affects: ubuntu-release-upgrader (Ubuntu)
     Importance: Undecided
         Status: New


** Tags: amd64 apport-bug dist-upgrade resolute wayland-session

-- 
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/2175455

Title:
  Complete system hard lock (GNOME Wayland freeze, unresponsive TTY,
  dead Caps Lock LED) during GUI Software Updater (`update-manager`)
  execution

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/ubuntu-release-upgrader/+bug/2175455/+subscriptions


-- 
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to