I have just done a clean install of Hardy and upgraded the firmware of
my card. Still no success.... (my other ubuntu desktop has no problems
with it) Is it still possible to use the orinoco drivers on Hardy? They
worked for me on Dapper & Edgy.

$ sudo hostap_diag wlan0
Host AP driver diagnostics information for 'wlan0'

NICID: id=0x8013 v1.0.0 (PRISM II (2.5) Mini-PCI (SST parallel flash))
PRIID: id=0x0015 v1.1.0
STAID: id=0x001f v1.8.2 (station firmware)

$ sudo lshw -class network
  *-network:0             
       description: Wireless interface
       product: Prism 2.5 Wavelan chipset
       vendor: Intersil Corporation
       physical id: 2
       bus info: [EMAIL PROTECTED]:01:02.0
       logical name: wifi0
       version: 01
       serial: 00:05:3c:06:c2:96
       width: 32 bits
       clock: 33MHz
       capabilities: pm bus_master cap_list logical wireless ethernet physical
       configuration: broadcast=yes driver=hostap firmware=1.8.2 latency=64 
module=hostap_pci multicast=yes wireless=IEEE 802.11b

$ iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wifi0     IEEE 802.11b  ESSID:""  Nickname:""
          Mode:Managed  Frequency:2.467 GHz  Access Point: None   
          Bit Rate:2 Mb/s   Sensitivity=1/3  
          Retry short limit:8   RTS thr:off   Fragment thr:off
          Power Management:off
          
wlan0     IEEE 802.11b  ESSID:""  Nickname:""
          Mode:Managed  Frequency:2.467 GHz  Access Point: None   
          Bit Rate:2 Mb/s   Sensitivity=1/3  
          Retry short limit:8   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=0/70  Signal level=-73 dBm  Noise level=-73 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

irda0     no wireless extensions.

$ iwlist scan
lo        Interface doesn't support scanning.

eth0      Interface doesn't support scanning.

wifi0     No scan results

wlan0     No scan results

irda0     Interface doesn't support scanning.

-- 
Orinoco_pci affected by re-enabled prism2 drivers
https://bugs.launchpad.net/bugs/63989
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.

-- 
ubuntu-bugs mailing list
ubuntu-bugs@lists.ubuntu.com
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to