Here's my dmesg output from when I resume from suspend and network- manager becomes useless, with no wired or wireless networks in the dropdown list (all in kernel -19):
[ 6.098851] b43legacy-phy0: Broadcom 4306 WLAN found [ 6.120545] b43legacy-phy0 debug: Found PHY: Analog 1, Type 2, Revision 1 [ 6.120574] b43legacy-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 [ 6.144519] b43legacy-phy0 debug: Radio initialized [ 6.157428] phy0: Selected rate control algorithm 'simple' [ 6.158087] b43legacy-phy0 debug: Ignoring unconnected 802.11 core [ 6.192526] tg3.c:v3.86 (November 9, 2007) [ 6.192564] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ 11 [ 6.280666] eth0: Tigon3 [partno(BCM95705A50) rev 3001 PHY(5705)] (PCI:33MHz:32-bit) 10/100/1000Base-T Ethernet 00:0d:56:e6:f8:50 [ 6.280681] eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] TSOcap[1] [ 6.280685] eth0: dma_rwctrl[763f0000] dma_mask[64-bit] [ 6.610381] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 7.308405] b43legacy-phy0 debug: Loading firmware version 0x127, patch level 14 (2005-04-18 02:36:27) [ 7.431745] b43legacy-phy0 debug: Chip initialized [ 7.432114] b43legacy-phy0 debug: 30-bit DMA initialized [ 7.432232] b43legacy-phy0 debug: Wireless interface started [ 7.432238] b43legacy-phy0 debug: Adding Interface type 2 [ 7.435297] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 21.128329] agpgart: Found an AGP 2.0 compliant device at 0000:00:00.0. [ 21.128365] agpgart: Putting AGP V2 device at 0000:00:00.0 into 4x mode [ 21.128412] agpgart: Putting AGP V2 device at 0000:01:00.0 into 4x mode [ 21.128461] [drm] Loading R200 Microcode [ 21.243677] tg3: eth0: Link is up at 100 Mbps, full duplex. [ 21.243691] tg3: eth0: Flow control is off for TX and off for RX. [ 21.251335] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Thanks again for looking into this. I can't believe it's just me having this exact issue--most everyone else posting on this bug seems not to be able to resume at all--but let me know if this is just due to having kluge left over from the upgrade from Gutsy and a fresh install will solve it. -- Kernel 2.6.24-17 - broken resume from suspend to RAM https://bugs.launchpad.net/bugs/226279 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
