----- Original Message -----
From: "Greg Ungerer" <[EMAIL PROTECTED]>
To: "uClinux development list" <uclinux-dev@uclinux.org>
Cc: <[EMAIL PROTECTED]>
Sent: Wednesday, February 14, 2007 5:54 PM
Subject: Re: [uClinux-dev] Could it possible to port uClinux to 51 based
MCU?
Hi Stevin,
[EMAIL PROTECTED] wrote:
a question, Could it possible to port uClinux to 51 based MCU with
large ram and rom?
You are going to need > 1MB of RAM, can any 51 based MCU's really
have that much?
Yes, there are 51 varients that have large avalable address spaces. Many of
the c compilers support bank switching as well. I know one company I
interviewed with that was running about 4MB with a bank switched 51.
Even then you might hit troubles with tool chain, you need a fully
featured c compiler (preferably gcc), not the "reduced" functionality
ones common on these little CPU's.
True, this will be the hard part. I don't know of anything that comes
close to a full function GCC like compiler for the 51. I have to do work
arounds almost any time I want to use the standard libarry with it.
Bobby
But hey, never say impossible. "Very difficult" might be close
to the mark though.
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Chief Software Dude EMAIL: [EMAIL PROTECTED]
SnapGear -- a Secure Computing Company PHONE: +61 7 3435 2888
825 Stanley St, FAX: +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia WEB: http://www.SnapGear.com
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev