Normally,
An effective External Glue logic coupled with your desired processor should help you.
Karthik Balaguru
[EMAIL PROTECTED] wrote: -----To: [email protected]
From: Allon Stern <[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED]
Date: 01/22/2008 05:51AM
Subject: [uClinux-dev] GPIO as address lines?
We're planning on connecting a Coldfire 5282 to a large flash, 64M;
there aren't enough address lines or chip selects to really do a
proper job.
Is there a way to set up the MTD driver to allow us to use GPIOs to
drive the high address lines on the flash without horking up the rest
of the system? Am I on the right track, but looking in the wrong
place? Or am I doomed?
-
allon
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
______________________________________________________________________
This email may contain confidential or privileged information for the intended recipient(s). If you are not the intended recipient, please do not use or disseminate the information, notify the sender and delete it from your system. Thanks
______________________________________________________________________
_______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev
