On 11/18/2009, "ucli...@browserseal.com" <ucli...@browserseal.com> wrote:
>Here we go again :) After I managed to compile uClinux for ARM GDB/Skyeye >target (with lots of sweat, tears and bugfixes) I tried to... you >guessed it, run it using Skyeye. Needless to say - it did not work. > >There are (so far) two problems: >1. I cannot get uart working in neither stdio nor pipe mode - there is >not output >2. After "running" for a while it starts spitting the following error >messages: > > >Bus read error, can not find corresponding bank for addr >0x1800000,pc=0x10a5df4 >Bus read error, can not find corresponding bank for addr >0x1800001,pc=0x10a5df4 >Bus read error, can not find corresponding bank for addr >0x1800002,pc=0x10a5df4 >Bus read error, can not find corresponding bank for addr >0x1800003,pc=0x10a5df4 >Bus read error, can not find corresponding bank for addr >0x1800004,pc=0x10a5df4 Just for the record, uClinux 20070130 works 100% with SkyEye, although you have to compile it for GDB/Armulator, not GDB/SkyEye. I will try to check what was changed since than, but any hints are welcome. >_______________________________________________ >uClinux-dev mailing list >uClinux-dev@uclinux.org >http://mailman.uclinux.org/mailman/listinfo/uclinux-dev >This message was resent by uclinux-dev@uclinux.org >To unsubscribe see: >http://mailman.uclinux.org/mailman/options/uclinux-dev _______________________________________________ uClinux-dev mailing list uClinux-dev@uclinux.org http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by uclinux-dev@uclinux.org To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev