Hi Geert,
On 14/08/11 00:27, Geert Uytterhoeven wrote:
On Thu, Aug 11, 2011 at 06:47,<g...@snapgear.com> wrote:
--- a/arch/m68k/kernel/Makefile
+++ b/arch/m68k/kernel/Makefile
@@ -1,5 +1,20 @@
-ifdef CONFIG_MMU
-include arch/m68k/kernel/Makefile_mm
-else
-include arch/m68k/kernel/Makefile_no
+#
+# Makefile for the linux kernel.
+#
+
+extra-$(CONFIG_MMU) := head.o
+extra-$(CONFIG_SUN3) := sun3-head.o
+extra-y += vmlinux.lds
+
+obj-y := entry.o m68k_ksyms.o process.o ptrace.o setup.o signal.o \
+ sys_m68k.o syscalltable.o time.o traps.o
+
+obj-y$(CONFIG_MMU_SUN3) += dma.o # no, it's not a typo
+obj-$(CONFIG_MMU) += ints.o module.o devres.o
On MMU, we unconditionally build module.c.
+devres-$(CONFIG_MMU) = ../../../kernel/irq/devres.o
+
+ifndef CONFIG_MMU
+obj-y += init_task.o irq.o
+obj-$(CONFIG_MODULES) += module.o
On nommu, it depends on CONFIG_MODULES.
However, most inside module.c is already protected by #ifdef CONFIG_MODULES.
Except for module_fixup(), which is empty for nommu. After moving the whole
module_fixup() inside #ifdef CONFIG_MMU, you can consolidate the module.o
entry in the Makefile.
Actually you don't even need to modify module.c to always build
at the moment. I can move to always building module.o, it costs
an extra 2 bytes in the final non-MMU/no-modules case :-)
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Principal Engineer EMAIL: g...@snapgear.com
SnapGear Group, McAfee PHONE: +61 7 3435 2888
8 Gardner Close FAX: +61 7 3217 5323
Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
