Hi Yaniv, I'm not very familiar with Microblaze, but I'll try to help.
There are several possible reasons: - SRAM cannot run at a higher frequency than Microblaze. So you need to reduce the SRAM Clock to 52 MHz or speed up Microblaze core to 104Mhz (for UmTRX boards). - Endianess. MicroBlaze is Big endian and SRAM (IS61NLP25672) follow little Endian so need to assign Buses in inverted order. e.g:: address11 to address0 and adress10 to adress1 and so on ... also applying this for data, bank and DQM busses. - Issue of latching edge. SRAM datasheet says to latch data at positive edge. Regards, Andrew Karpenkov 2013/5/21 Yaniv Shiber <[email protected]> > Hi All, > > I wish to work with the Synchronize Sram and to connect it to the FPGA > Microblaze. > Does anyone was able to use and communicate with the SRAM? > If so, can U help with the configuration of the EMC? > I read the EMC datasheet and they describe different way for connecting > the EMC with the SRAM. Maybe U know on a problem when working with SRAM? > > thanks in advance, > > Yaniv >
