Zitat von "W.C.A. Wijngaards" <[email protected]>:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi Andreas,
On 11/02/2010 11:38 AM, [email protected] wrote:
The request is orginating at localhost with "nameserver 127.0.0.1" as
the only content in resolv.conf so routing should not be the problem. If
have disabled "interface-automatic: yes" because the machine is
multihomed and have bound unbound to the needed interfaces "by hand"
with the "interface:" statement. I have also set "do-ip6: no" because
the machine has ipv6 capabilities but no ipv6 connectivity until yet.
Looks like this is reasonable config to me.
So the packetdump was from the eth interface, and did not include lo0
traffic, that is why the reply is not in the packet capture?
Best regards,
Wouter
The packet capture is from the connection unbound (10.5.0.1) ->
upstream bind (10.5.0.3) to see if bind deliver results or not. If
have done no localhost capture but i can try later. It is a bit
difficult because it's the main resolver for the internal net and
people don't like to be without internet access today ;-)
Regards
Andreas
_______________________________________________
Unbound-users mailing list
[email protected]
http://unbound.nlnetlabs.nl/mailman/listinfo/unbound-users
