paul- wrote: > Alright, > > I have something that is a bit easier to install....Depending on how > testing goes, we should be able to integrate this into the web > interface. > > INSTALLATION > > > > - Go to the extension browser from the main menu. - Select piCorePlayer Sourceforge Repository - Find and Select pcp-apmode.tcz and the press the Load button - Run Backup from the main menu to backup setting changes that > occurred during load. > > > > That's it, after it loads successfully, goto the wifi page and make > sure that you have not disabled the rpi3 wireless chip. Then > reboot. > > USE > > > > - Default IP address of the wifi interface is 10.10.10.1 - Default SSID is pCP - Default passphrase is piCorePlayer - Default Channel is 7 - If the ethernet cable is plugged in, then pCP will act as a DNAT > router. > > > > > REMOVE > > > > - start an ssh session. - tce-audit builddb - tce-audit delete pcp-apmode - Would also be good to remove the line in /opt/bootlocal.sh that > runs pcp-apmode > > > > > -------UNDER THE HOOD--------- > > > > - When pcp-apmode.tcz loads, it will automatically load all of it's > dependencies, including hostapd, dnsmasq, iptables. It will also > inject a startup command into /opt/bootlocal.sh - config files are at /usr/local/etc/pcp/hostapd.conf and > /usr/local/etc/pcp/dnsmasq.conf > > >
This is great. Have you had a chance to test on a pi Zero W? This would be the ideal portable solution. ------------------------------------------------------------------------ wtnh's Profile: http://forums.slimdevices.com/member.php?userid=36993 View this thread: http://forums.slimdevices.com/showthread.php?t=108341 _______________________________________________ unix mailing list unix@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/unix