Stace, Try to boot without monitor cable connected and reset PRAM (command+optio+P+R when reboot)? Then connect monitor back and see what happens.
Good luck, Olli [EMAIL PROTECTED] wrote: > Hey all, > > Just this morning, I had a monitor I think go bad that was connected to my > 9600, running Jaguar. > > To test it in another resolution, or also to even use a backup till I get a new > one (none of my backup monitors will be able to handle the resolution the Mac is > currently set to), I'm going to need to change to a lower resolution. > > So my question is, how can I do that? Currently, on the Mac, you can't see a > thing on it. I want to try a different resolution to see if it works before > buying a new one. And like I said, I can't even plug a backup monitor into it > until I get the current resolution changed. > > I have SSH enabled on it, so, is there anything I can do from a terminal to > change it? > > Or, would I be able to boot from an OS X CD to make changes? Or can't 9600's > boot from an X CD? > > Thanks, > Stace > -- Unsupported OS X is sponsored by <http://lowendmac.com/> Support Low End Mac <http://lowendmac.com/lists/support.html> Unsupported OS X list info <http://lowendmac.com/lists/unsupported.html> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive <http://www.mail-archive.com/unsupportedosx%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
