I have
- Propox MMsam7s minimodule with Atmel at91samt7s256
- Propox EVBsam7s evaluation board
- Propox ARMcable I (Wiggler clone)
- urjtag 0.10
This hardware setup works with OpenOCD as well as Rowley's CrossStudio.
When I try to detect, this is what happens
jtag> cable wiggler ppdev /dev/parport0
Initializing ppdev port /dev/parport0
jtag> detect
IR length: 4
Chain length: 1
Device Id: 00111111000011110000111100001111 (0x000000003F0F0F0F)
Manufacturer: ARM
Cannot open /usr/local/prog/urjtag-0.10/share/urjtag/arm/PARTS
Unknown part!
chain.c(149) Part 0 without active instruction
chain.c(200) Part 0 without active instruction
chain.c(149) Part 0 without active instruction
So, there is no arm directory. I tried linking the atmel to
arm, but this did not help.
I have searched all PARTS but none match this Device Id.
Any ideas?
Regards
/Lars Hamrén
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:
Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
UrJTAG-development mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/urjtag-development
