Ben, i am not sure if you are already aware of this, but in case you ever want to test your app without tsNet in LC 9.5.x or higher or you want to create it with LC 9.5.x or higher but without using tsNET you could unload tsNet in LC IDE before testing or creating the standalone. LC then uses only the 'standard' libUrl library.
To disable tsNET execute this in the message box dispatch "revunloadlibrary" to stack tsnetliburl Please keep in mind that you have to unselect tsNet in the Inclusions section of the standalone builder in case you've set the standalone settings to manually select the inclusions. To enable tsNET again execute this in the message box dispatch "revloadlibrary" to stack tsnetliburl Regards, Matthias > Am 07.11.2021 um 18:50 schrieb Mark Waddingham via use-livecode > <use-livecode@lists.runrev.com>: > > I think tsNetSetTimeouts is what you need :) > > Warmest Regards, > > Mark > > Sent from my iPhone > >> On 7 Nov 2021, at 16:51, Ben Rubinstein via use-livecode >> <use-livecode@lists.runrev.com> wrote: >> >> >> I'm finally moving an app from LC 6.7 to LC 9.6.5 (huge thanks to Mark W for >> fixing the accumulating/sorting delay loops, which has made this possible). >> >> I've hit what I hope is the last hurdle: at one point in its processing, the >> app has to load a resource over HTTP, which is s.l.o.w. - it typically takes >> around 8 minutes at the moment. >> >> By setting the sockettimeoutinterval to the extreme 1800 (i.e. half an hour) >> this has been fine. >> >> But under 9.6.5, in spite of this setting, it craps out within a minute with >> the message >> tsneterr: (28) Operation too slow. Less than 1000 bytes/sec transferred >> the last 30 seconds >> >> Does tsneterr ignore the sockettimeoutinterval? Is there some other property >> I can set to persuade it to be patient? >> >> TIA, >> >> Ben >> >> _______________________________________________ >> use-livecode mailing list >> use-livecode@lists.runrev.com >> Please visit this url to subscribe, unsubscribe and manage your subscription >> preferences: >> http://lists.runrev.com/mailman/listinfo/use-livecode > > > _______________________________________________ > use-livecode mailing list > use-livecode@lists.runrev.com > Please visit this url to subscribe, unsubscribe and manage your subscription > preferences: > http://lists.runrev.com/mailman/listinfo/use-livecode _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode