Sorry , we can all make mistakes , I missed the ANSWER bit ! The problem ONLY happens when ANSWER is used in the script AND a password is set in the Standalone settings. Everything works fine in IDE
I corrected some minor script errors as suggested which made no differrence. Any script I use with ANSWER and PASSWORD SET in Standalone builds 100% in older versions of Rev and always have. The same scripts ONLY fail to build in REV 3.0 on several different Machines It does happen ! hopefully someone understands Rev enough to find the solution. Please............. Regards Camm ---- "J. Landman Gay" <jac...@hyperactivesw.com> wrote: > Colin Holgate wrote: > > I just read over the previous messages in this thread (harder to do than > > you would think, if you've already deleted the messages!). There's one > > point of confusion that might be worth asking about. In the original > > message 'camm' said that the problem only happened when setting a > > password in the standalone settings, but then in the next message > > corrected that to say the problem only happens in "ANSWER" is used in > > the script. > > > > So which of those two is it? Most of the replies gave advice based on it > > being to do with having a password. It would be very hard to reproduce > > the problem if you are doing the wrong steps. > > Both. If any script in the stack uses the "answer" command and a > password has been set in the standalone builder, on Camm's machines the > standalone will fail. What I think may be happening is some sort of > conflict that prevents the answer dialog from appearing, but since it is > a standalone, the failure is silent. > > The sample stack he sent to the support queue had some very convoluted > script messaging. I wondered if that was the cause and suggested some > simplification techniques, but I didn't hear back about that. > > At any rate, even with the existing scripts, I was able to build and use > his sample standalone normally, even after adding a password to the SB. > > -- > Jacqueline Landman Gay | jac...@hyperactivesw.com > HyperActive Software | http://www.hyperactivesw.com > _______________________________________________ > use-revolution mailing list > use-revolution@lists.runrev.com > Please visit this url to subscribe, unsubscribe and manage your subscription > preferences: > http://lists.runrev.com/mailman/listinfo/use-revolution _______________________________________________ use-revolution mailing list use-revolution@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-revolution
