It seems that this is not possible.
You could rewrite your scenario with <if>
Jan
<ac:if>
<or>
<equals arg1="${value}" arg2="foo"/>
<equals arg1="${value}" arg2="bar"/>
</or>
<then>
<echo>foo</echo>
<echo>or bar</echo>
</then>
</ac:if>
>-----Ursprüngliche Nachricht-----
>Von: Marco Gutsche [mailto:[email protected]]
>Gesendet: Dienstag, 18. Mai 2010 08:11
>An: [email protected]
>Betreff: Re: multiple switch case
>
>Hello,
>
>Thanks, but I found this link and the example only shows one case and
>I'm not able to modify it to use multiple case for one following
>instruction (like my example).
>
>Regards
>Marco
>
>Am 17.05.2010 20:56, schrieb reno:
>> Marco,
>>
>> a bit of "googling" will give you that link:
>> http://ant-contrib.sourceforge.net/tasks/tasks/switch.html
>>
>> hope this help
>>
>> S.
>>> Hello,
>>>
>>> it is possible to use multiple case in a switch command,
>for example:
>>>
>>> switch value:
>>> case a:
>>> case b:
>>> echo "a or b"
>>> case c:
>>> echo "c"
>>>
>>> Thank a lot.
>>>
>>> Regards
>>> Marco
>>>
>>>
>>>
>---------------------------------------------------------------------
>>> To unsubscribe, e-mail: [email protected]
>>> For additional commands, e-mail: [email protected]
>>>
>>>
>>>
>>
>>
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: [email protected]
>> For additional commands, e-mail: [email protected]
>>
>>
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [email protected]
>For additional commands, e-mail: [email protected]
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
