Thanx Arvind. Is the steady rate configurable through the flume configurations? Otherwise, that would mean we need to adjust through adjusting the total number of Sinks? In case I just need a single Source/Sink pairing and still would want to control the drain rate?
Regards Pravesh On Tue, May 6, 2014 at 9:44 PM, Arvind Prabhakar <[email protected]> wrote: > This is indirectly available in Flume (NG) via the number of sinks you > setup. Each sink operates on a single thread that drains the channel at a > steady rate. If you want to have a lower drain rate, reduce the number of > sinks; and conversely increase them for higher drain rate. > > Regards, > Arvind Prabhakar > > > On Tue, May 6, 2014 at 12:05 AM, pravesh suyal <[email protected]>wrote: > >> >> Dear Flume community, >> >> Is there is any alternative to the Flume-OG Chokes in the Flume-NG? >> >> Chokes served the purpose well to control the data transfer rate limit >> across the Sources-to-Sinks. >> >> Is this been dropped from Flume-NG purposely? OR there is an alternative? >> >> Regards >> -- >> Pravesh Suyal >> > > -- Pravesh Suyal
