Thanks, Gabriel. If you have any spare cycles, it might be good to add this
to the CSV Bulk Load page and/or as an FAQ as it's come up a few times.

    James

On Fri, Jan 29, 2016 at 11:03 PM, Parth Sawant <[email protected]>
wrote:

> Hi Gabriel,
> This worked perfectly.
>
> Thanks a lot.
> Parth S
>
> On Fri, Jan 29, 2016 at 10:29 PM, Gabriel Reid <[email protected]>
> wrote:
>
>> Hi Parth,
>>
>> Setting the "fs.permissions.umask-mode" config setting to "000" should
>> do the job. You can do this in your hadoop config on the machine where
>> you're submitting the job, or just supply it as the leading
>> command-line parameter as follows:
>>
>>     hadoop jar phoenix-client.jar
>> org.apache.phoenix.mapreduce.CsvBulkLoadTool
>> -Dfs.permissions.umask-mode=000 <other command line args>
>>
>> - Gabriel
>>
>>
>> On Fri, Jan 29, 2016 at 8:34 PM, Parth Sawant <[email protected]>
>> wrote:
>> > Hi
>> > I'm trying to run the PhoenixBulkLoader command as user 'X' where user
>> 'X'
>> > != hbase. Basically the bulkloader waits on loading the HFiles from
>> hdfs if
>> > I run the command as any other user except 'hbase'.
>> > Is there some way to run the command as just any user except 'hbase' on
>> an
>> > un-secure cluster.
>> >
>> > Set-up Information:
>> > Hadoop : 2.7.1.2.3.4.0
>> > Phoenix : 4.4
>> > Hbase : 1.1.2.2.3.4.0
>> >
>> >
>> > Thanks for your help.
>> >
>> > Regards
>> > Parth S
>> >
>>
>
>

Reply via email to