Hi Jack, There is a config file named servers in $DCS_INSTALL_DIR/conf which used to set the numbers of mxosrvr. You can modify this file and restart the DCS.
dcsstop; dcsstart; Here is the note for the configuration, you can get the information from http://trafodion.incubator.apache.org/docs/dcs_reference/index.html#_run_modes "In addition, a multi-node deploy requires that you modify *conf/servers*. The *servers* file lists all hosts that you would have running DcsServers, one host per line or the host name followed by the number of master executor servers. All servers listed in this file will be started and stopped when DCS start or stop is run" Best Regards, Weiqing On Sat, Jul 29, 2017 at 3:19 PM, Huang, Jack <jack.hu...@dell.com> wrote: > Hi Trafodioner, > > I installed the trafodion with the listed configuration. > > As a beginner, I set the dcs_cnt_per_node as 100 in my installation, and > sqlci display like this. > > After some testing, I found the count number is not enough for my testing. > > So the question is how can I change the number but did not any > re-installation? > > > > Process Configured Actual Down > > ------- ---------- ------ ---- > > DTM 2 2 > > RMS 4 4 > > DcsMaster 1 1 > > DcsServer 1 1 > > mxosrvr 100 98 2 > > RestServer 1 1 > > > > > > +------------------+---------------------------------------- > --------------------------+ > > | config type | value > | > > +------------------+---------------------------------------- > --------------------------+ > > | dcs_cnt_per_node | 100 > | > > | dcs_ha | N > | > > | first_rsnode | trafodion > | > > > > > > *Jack Huang* > > *Dell* *EMC* | CTD MRES Cyclone Group > > mobile +86-13880577652 > > jack.hu...@dell.com > > *[image: dell_emc_proven_badge_RGB_small]* > > > > > > >
