Be sure to include the "@local" affiliation for the username such as: xmlrpc_username=vclsystem@local
I haven't experienced this problem, but there's a chance things won't work correctly if you have unusual special characters in the password. As a test, you could try to set the password to something alphanumeric and modify vcld.conf accordingly and then try the "Test RPC-XML Access" function again. If you continue to have trouble, there are probably some warning messages being written to /var/log/vcld.log as a result of setting the password or testing RPC-XML. This output would be helpful for troubleshooting. To isolate the "vcld -setup" output, you can direct the output to a specific log file via the command line: vcld -setup -log=/var/log/vcl-setup.log Please clean out any passwords and send the log file output. On Tue, Apr 15, 2014 at 9:31 AM, Tariq Daradkeh <[email protected]> wrote: > hello Andy, > thank you for reply, yes i did configure the configure xmlrpc_username > and xmlrpc_pass in vcld.conf. > but it dose not work also i reset the password lot of time by > /usr/local/vcl/bin/vcld > -setup and it didn't work. > regards > tariq > > > On Tue, Apr 15, 2014 at 9:15 AM, Andy Kurth <[email protected]> wrote: > >> Did you get RPC-XML working? You need to configure xmlrpc_username and >> xmlrpc_pass in vcld.conf. >> Regards, >> Andy >> >> >> >> On Sat, Apr 12, 2014 at 2:35 PM, zvclproject zvclproject < >> [email protected]> wrote: >> >>> hello, >>> >>> i'm a new user which i just have finished installation the VCL >>> management node and i issued the /usr/local/vcl/bin/vcld -setup command to >>> start capture an base image i have two error one for the xmlrpc_pass >>> configured not correct knowing that i checked all configuration and it is >>> correct and once i make a test Test RPC-XML Access under VCL Base Module i >>> get following message >>> >>> K: verified user affiliation exists in the database: 'Local' >>> OK: verified user exists in the database: 'vclsystem@Local' >>> PROBLEM: xmlrpc_pass value configured in /etc/vcl/vcld.conf is not >>> correct >>> >>> FAILURE: RPC-XML access is not configured correctly, errors encountered: >>> 1 >>> >>> >>> then i start selecting the VCL Image State Module then Capture Base Image >>> >>> and i got following error >>> ERROR: unable to retrieve information for computer ID: 3 >>> >>> >>> please any idea. >>> >>> thank you >>> >>> >>> >> > > > -- > Kinds Regards > Tariq Daradkeh >
