正文已经贴了交换机配置,Cisco 2960s交换机。
------------------ 原始邮件 ------------------ 发件人: "linux...@gmail.com";<linux...@gmail.com>; 发送时间: 2014年7月21日(星期一) 中午1:20 收件人: "users-cn"<users-cn@cloudstack.apache.org>; 主题: Re: 为什么我的双网卡绑定,总是一个网卡有流量呢。 mode=0:平衡负载模式,有自动备援,但需要”Switch”支援及设定。 http://support.huawei.com/ecommunity/bbs/10155553.html 2014-07-18 13:39 GMT+08:00 虚无缥缈 <83675...@qq.com>: > A、B两台设备,都是双网卡绑定,mode=0,交换机上也做了端口组,交换机是cisco > 2960,A上起了nfs,B上挂载nfs,然后进行dd测试,cacti上看总是一个端口流量,手动down掉一个网卡,另外一个网卡才有流量。 > > A: > [root@backup ~]# cat /proc/net/bonding/bond0 > Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) > > > Bonding Mode: load balancing (round-robin) > MII Status: up > MII Polling Interval (ms): 100 > Up Delay (ms): 0 > Down Delay (ms): 0 > > > Slave Interface: em1 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 1 > Permanent HW addr: > Slave queue ID: 0 > > > Slave Interface: em2 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: > > > > B: > root@storage-xen bak_201]# cat /proc/net/bonding/bond0 > Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) > > > Bonding Mode: load balancing (round-robin) > MII Status: up > MII Polling Interval (ms): 100 > Up Delay (ms): 0 > Down Delay (ms): 0 > > > Slave Interface: em1 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: > Slave queue ID: 0 > > > Slave Interface: em2 > MII Status: up > Speed: 1000 Mbps > Duplex: full > Link Failure Count: 0 > Permanent HW addr: > Slave queue ID: 0 > > > > 交换机: > interface Port-channel1 > switchport access vlan 150 > switchport mode access > > > > interface GigabitEthernet0/3 > switchport access vlan 150 > switchport mode access > channel-group 1 mode on > spanning-tree portfast > ! > > interface GigabitEthernet0/10 > switchport access vlan 150 > switchport mode access > channel-group 1 mode on > spanning-tree portfast -- 白清杰 (Born Bai) Mail: linux...@gmail.com 敬畏耶和华是智慧的开端